Publicité
EN
CHARGER 6/12V
PROCHARGER EVO 10A WITH LED AND AMMETER
TECHNICAL DATA:
Suitable for sealed lead-acid, gel, AGM batteries
Input voltage: 230/240V
Frequency: 50 Hz
Output voltage: 6/12V
Charging current: 0-10A
Power consumption: 110 W
Battery capacity: 5-120Ah
Indicator: LED + AMMETER
IP20
OPERATING TEMPERATURE: -10/+40
FUSE: 3.15 A
CABLE: 145CM
INSTRUCTIONS FOR USE:
1.
Connect the charger to the battery respecting the polarity.
2.
Check the voltage of the battery to be charged. Then select the correct voltage using
the button on the charger (6/12V).
3.
Connect the charger to the power outlet.
4.
Press the button to the ON position. If the connection is correct, the charging process
will begin and the CHARGE indicator will light up. If the connection is incorrect, the
ERROR indicator will light up. In this case, turn off the charger, correctly connect the
cables to the poles, and repeat steps 1-2-3.
5.
Turn the knob to adjust the desired charging value based on the type of battery to be
charged. To know which amperage to choose:
• Between 0 and 10A, calculate 10% of the battery capacity (e.g., for a battery with a
capacity of 60Ah, set to 6A).
• For batteries over 100Ah, always set to maximum (10A).
6.
Monitor the charging status on the display. When the battery is fully charged, the
"power full" display will light up.
7.
Charging can be interrupted at any time by disconnecting the cable from the power
outlet.
8.
For maintenance function: the charger will maintain the output at 13.7 V / 0.2 - 0.3 A
(maintenance charge) when the battery is fully charged.
AMMETER:
•
Connect the charger to the power outlet, then connect the battery with the cables
respecting the polarity.
•
Select the voltage mode based on the connected battery type (6 V/12 V).
•
Turn on the start switch (On/Off ).
•
Turn the knob switch to adjust the output current (0 - 10 A), the ammeter will show the
output current.
Publicité
