Publicité
BFL(T)
Demontage van het mechanisme
Type BFL(T) on CR2/CU2(/B)/
CU4/CU2-15:
1. Unlock the motor by
interrupting the power supply.
2. Loosen the two fixing bolts of
the motor and remove the old
motor.
3. For types BFLT: unscrew the
thermo-electric fuse and
remove it.
Montage van het mechanisme
On damper type CR2/CU2(/B)/CU2-15/CU4:
1. Make sur the damper blade is
closed.
2. Place the position indicator
arrow on the motor on position
0°.
3. Fix the motor, L side visible, with
screws and spring washers.
4. Connect the motor according to
the wiring diagram.
If the product is manipulated in any other way than described in this manual, Rf-Technologies
will decline any responsibility and the guarantee will immediately expire!
Servomotor Belimo
Type BFL(T) (-SR) on CR60/CR120/
CRS60/CU-LT(1s):
1. Unlock the motor by
interrupting the power supply.
2. Loosen the two fixing bolts of
the motor and remove the old
motor.
3. For types BFLT: unscrew the
thermo-electric fuse and
remove it.
5. Place the thermo-electric fuse
on the plate and fix with 2
screws (type BFLT). If the old
motor was not equipped with
a thermo-electric fuse, the
membrane must be perforated
first.
6. Test that the motor functions
properly.
7. Apply the label 'KIT' to the
motor and fill in the details.
On damper type CR60/CR120/CRS60/CU-LT(1s):
1. When changing mechanism
type (before ONE or MFUS(P)),
remove the old plug and replace
by the new, closed plug
2. Make sur the damper blade is
closed.
3. Place the position indicator
arrow on the motor on position
0°.
4. Fix the motor, L side visible, with
screws and spring washers.
5. Connect the motor according to
the wiring diagram.
K128-D
01/2025
6. Place the thermo-electric fuse
on the holder and fix with 2
screws (type BFLT). If the old
motor was not equipped with
a thermo-electric fuse, the
membrane must be perforated
first.
7. Test that the motor functions
properly.
8. Apply the label 'KIT' to the
motor and fill in the details.
13
Publicité
