Publicité
Air+
2.5
Installing the DC plug
2.6
Electrical connection of the controls
Power supply
Damper motor
EN
1) Guide the power cable with plug through the rear
1) Make sure that all the components are correctly con-
2) Plug the mains cable plug into the electrical point.
3) Wait approximately three minutes after the plug has
Firebox temperature
4) The air control system (rotary knob) should be com-
5) The air control system (rotary knob) did not com-
• Plug correctly connected to the mains.
• Air control system is functioning. Any LED display lights
are flashing.
• All components are correctly connected: check whether
all connectors are correctly connected.
• Is the temperature scale in the combustion chamber
above the ambient temperature? If the stove is warm
due to a previous firing process or if the stove is just
warming up, this will be detected by the air control sys-
tem. Therefore the calibration process will be prevented
and the air control system will switch straight to com-
bustion phase 1.
• Check the rotary knob. It should be capable of being
turned against a slight resistance. Otherwise the rotary
knob and all connected components must be checked.
Despite the automatic air control system the position of
the damper doors can be manually adjusted.
panel and fasten it as per the picture.
nected.
Test the air control system and set the minimum and
maximum motor position - calibration process.
been plugged in and then check whether the air con-
trol system (rotary knob) has fully opened and closed
by itself again after these three minutes have expired.
pletely closed again after the calibration process.
pletely open and close during these three minutes.
Therefore check the following:
1 | General
17
Publicité
