Publicité
1 | General
2.3
Converting the rotary control unit
Fig. 4: Rotary control unit conversion
2.4
Installing the control unit
Fig. 5: Control unit
16
EN
NOTICE
Before dismounting, mark the position of the wooden
handle as shown in the illustration.
1) Dismount the rotary control unit, as shown in the pic-
ture below.
2) Remove the shim.
3) Then reassemble the rotary control unit.
NOTICE
The grub screw must be removed in order to be able to
dismount the rotary control unit. Afterwards the grub screw
must be reinstalled.
1) Insert the 125 mm hexagon rod supplied into the air
box and turn fully counterclockwise.
2) Then slide the magnetic driving plate onto the hex
rod.
3) Now slide the preassembled unit (motor incl. controls)
on to the hex rod and fix the unit on to the air box us-
ing the two Torx screws shown, which must be re-
moved beforehand.
4) Then mount both the universal cardan joints included
in the set and the rotary control unit.
ð Ensure that the rotary control unit is in the position
shown above before mounting.
5) Then fix the screws on the cardan joints with the rod
system!
Air+
Publicité
