Publicité
Charging the battery
Solar Cell
Expose to light when the remote is not in use. This will extend the
remote's operating time.
USB port (C-type) for charging
Used for quick charging. The LED on the front will light when
charging. When the battery is fully charged, the LED will turn off.
• The USB Cable is not provided.
– It is recommended to use an original Samsung charger.
Otherwise, it may cause performance degradation or failure
of the product. In this case, the warranty service is not
applicable.
– When the remote control does not work due to low battery,
charge it by using the USB-C type port.
Fire or explosion may occur, resulting in damage
to the remote control or personal injury.
• Do not apply shock to the remote control.
• Be careful not to let foreign substances such as
metal, liquid, or dust come in contact with the
charging terminal of the remote control.
• When the remote control is damaged or you
smell smoke or burning fumes, immediately
stop operation and then repair it at the
Samsung service center.
• Do not arbitrarily disassemble the remote
control.
• Be careful not to let infants or pets suck or
bite the remote control. Fire or explosion
may occur, resulting in damage to the remote
control or personal injury.
English - 10
04 Initial Setup
When you turn on your TV for the first time, it immediately
starts the Initial Setup. Follow the instructions displayed on the
screen and configure the TV's basic settings to suit your viewing
environment.
• You will need a Samsung Account to access our network-
based smart services. If you choose not to log in, you will only
get a connection to terrestrial TV (applicable to devices with
tuners only) and external devices, e.g. via HDMI.
Using the TV Controller
You can turn on the TV with the TV Controller button at the
bottom of the TV, and then use the Control menu. The Control
menu appears when the TV Controller button is pressed while
the TV is On.
• The screen may dim if the protective film on the SAMSUNG
logo or the bottom of the TV is not removed. If protective film
is attached, remove the film.
Control menu
TV Controller button / Remote control sensor
05 Connecting the HDBase-T
HDBase-T connection of The Terrace is built-in for transmission of
audio and video data. It does not support transmission of power,
Ethernet and control signals including IR and RS232.
– Up to HDMI 1.4 is supported.
– CEC does not operate when the TV is Off.
General
• The appearance may differ depending on the product.
• Connecting parts may differ in different products.
• Data transmission is not available if HDBase-T (Rx) is
connected to HDBase-T (Tx) through a hub.
• While installing the product, be sure to use the cables and TX
devices certified by the HDBase-T Alliance.
• When connecting an external device via HDBase-T, for the
maximum resolution, use a certified TX device that supports
4K 30 Hz.
• This port (HDBT port on the TV) does not support ARC (eARC).
Publicité
