Electrolux ERN3001FOW Notice D'utilisation page 11

6. WHAT TO DO IF...
CAUTION!
Before troubleshooting, discon-
nect the power supply.
Only a qualified electrician or com-
petent person must do the trou-
bleshooting that is not in this man-
ual.
Problem
The appliance is
noisy.
The appliance does
not operate.
The light device
does not work.
The compressor op-
erates continually.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Possible cause
The appliance is not instal-
led properly.
The plug is not connected
to the mains socket cor-
rectly.
The appliance is switched
off.
The appliance has no
power. There is no voltage
in the mains socket.
The light device is in
stand-by.
The unit is defective.
The temperature is not set
correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The food temperature is
too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
ENGLISH
There are some sounds during
normal use (compressor, refriger-
ant circulation).
Solution
Check if the appliance
stands stable (all the feet
should be on the floor).
Connect the plug to the
mains socket correctly.
Switch on the appliance.
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Close and open the door.
Refer to "Replacing the
control unit".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the food temperature
decrease to room tempera-
ture before storage.
Decrease the room temper-
ature.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
11