Publicité
ASSEMBLY INSTRUCTIONS
6. Attach supply lines (H) to shut-off valves
(not included) and hand tighten. Using two
wrenches (not included), finish with one-half turn.
Do not overtighten.
7. Remove plastic cap from discharge tube (L),
then attach quick connector (J) to discharge
tube (L). Pull down on quick connector (J)
to ensure it is secure.
Note: For removal, see QUICK
CONNECTOR REMOVAL, page 8.
8. Unscrew preassembled screw on weight
(K). Locate lowest point of the hose (I) on
the spout side and attach weight (K) by
reassembling halves and tightening
preassembled screw.
6
1
7
L
J
8
To spout
I
K
6
H
1
2
1
3
K
2
Publicité
