Publicité
Fitting
Only use saw blades the maximum permitted speed of which is higher than the no-
load speed of the power tool.
Charging the Battery
Use only the chargers listed on the accessories page. Only these chargers are matched to
the lithium-ion battery of your power tool.
Note: The battery is supplied partially charged. To ensure full battery capacity, fully charge the battery in
the charger before using your power tool for the first time.
The lithium-ion battery can be charged at any time without reducing its service life. Interrupting the
charging process does not damage the battery.
The lithium-ion battery is protected against deep discharge
by the "Electronic Cell Protection (ECP)". When the battery is discharged, the power tool is switched off by
means of a protective circuit: The application tool no longer rotates.
Do not continue to press the On/ Off switch after the power tool has automatically
switched off. The battery can be damaged.
Follow the instructions on correct disposal.
Removing the battery
The battery (1) is equipped with two locking levels to prevent the battery from falling out if the battery
release button (11) is pressed unintentionally. As long as the battery is inserted in the power tool, it is held in
position by means of a spring.
To remove the battery (1), press the release button (11) and pull the battery to the rear and out of the power
tool. Do not use force to do this.
Battery Charge Indicator
The five green LEDs of the battery charge indicator indicate the state of charge of the battery (1). For safety
reasons, it is only possible to check the state of charge when the power tool is at a standstill.
- All LEDS illuminated: The battery is fully charged.
- 2-5 lights The battery has an adequate remaining charge.
- 1 light: The battery is empty, recharge the battery.
If no LED lights up , then the battery is defective and must be replaced.
EN
7
Publicité
