vitapur CLASSE A NSF-55 Manuel De L'utilisateur Et Instructions D'installation page 12

t
roubleShootIng
PROBLEM
Warm water output
Unit leaking water
No power to UV lamp
when system is plugged
in
System has power but UV
lamp is not coming on
(visible / audible alarm
activated)
System is vibrating
Excessive heat
generated
*Water Hammer: Sudden closure of a control valve or stopping of a pump produces excessive pressure surges in a
pipeline. These pressure surges can cause significant damage to equipment and/or appliances directly attached to
the water line. Water hammer is usually noted due to the characteristic banging sounds when valves on the line are
suddenly closed. Water hammer conditions must be immediately remedied, and damage to systems as a result of this
condition are not covered under warranty.
If you experience trouble with your system other than the symptoms described above, please visit:
g :
uIde
POSSIBLE CAUSE
Water sitting in UV reaction chamber
and heating up due to infrequent use
Misaligned or cross-threaded
connections on inlet / outlet ports
Excessive water pressure
Water hammer* causing pressure spikes
GFCI wall socket is tripped
Lamp not installed correctly
Lamp failure
Not mounted securely
Water hammer* causing vibrations
Not being allowed sufficient space for
cooling
Operated in an excessive ambient
temperature
Water temperature is too high
Engineered for Health - Designed for Life
Canada: 400 Southgate Dr Guelph, ON, N1G 4P5
Phone :1-888-5-WATER-0 Fax :519-837-8913
Water Technologies
USA: 1270 Flagship Dr. Perrysburg, OH, 43551
Phone: 1-419-874-6770
www.greenwaywt.com
Water Technologies
11
SUGGESTED SOLUTION
Run tap for a short period of time
Reinstall to ensure a solid connection
with ports
Install pressure regulator ahead of
system
Install a "Water Hammer" arrestor in
system
Reset, following manufacturer's
instructions provided with the outlet
Check socket with other appliances
Ensure lamp is installed correctly with
electrical fitting (must be snug)
Replace UV lamp
Secure fasteners
Install a "Water Hammer" arrestor in system
Clear space for cooling (min. 6-12" / 15-
30 cm clearance around unit)
Unplug unit until temperature is within
ambient operating conditions
Ensure treatment is on cold water side
only (prior to heating of water)
Fax: 419-874-6769