Publicité
TROUBLE SHOOTING GUIDE CHECKLIST
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR
PRODUCT WITH THE POWER CONNECTED. DON'T JUST UNSCREW
THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER FROM
THE RECEPTACLE.
TROUBLE
PROBABLE CAUSE
Blown fuse
Motor does
Tripped breaker
not run.
Plug disconnected
Corroded plug
Low water level
Thermal overloaded
Defective motor
Jammed impeller
Pump does
not deliver to
Blocked suction/inlet
full capacity.
Discharge leak
Blocked line/pipe
Worn impeller
Defective motor
TO THE END CONSUMER
If you have any problems with the product, before advising the store, where you've
purchased the pump, please contact us at 514 337-4415, and ask for our sales
department, and they will be pleased to help you with any questions you might have,
concerning your installation.
4
FOR INFORMATION | TEL : 514.337.4415 | FAX : 514.337.4029
ACTION
Replace
Reset
Re-install
Clean prongs
Add water and verify
Unplug the pump for 15 minutes
then restart.
Replace/repair
Clean
Check for debris in pit and clean
Repair
Check for debris or ice
Repair/replace
Replace/repair
Publicité
