Publicité
All manuals and user guides at all-guides.com
Fax +32 030 9904733
pool (to avoid drops of water falling on the heater or the heater falling in the water), or in places
where it could be subject to shocks.
• Make sure that the fan heater is working correctly: if not, turn the heater off and have it checked by
professionally qualified personnel.
• Make sure that the air-intake grid is not obstructed by objects, fabrics or anything else to avoid the
heater overheating or breaking.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly. Check that no other high absorption appliances are connected to the same
power source.
• In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous and
render void the warranty.
• The appliance can be used standing on a level horizontal surface or fastened vertically to a wall.
Instructions for installation are given below:
Horizontal installation
The surface must be stable, rigid, and not sloping (otherwise the appliance could tip), ample and
free of any debris. Shelves cannot be used.
Vertical installation
Follow the indications given in the illustrations when fitting the appliance to the wall: Pay attention
not to perforate any pipes or conducts inside the wall. The fastening holes must be horizontal with
an inter-axis of 162mm, at a distance of at least 50cm from the ceiling and side walls, and at least
120cm from the floor. The hole for the locking flange must be made 170mm below the previous 2.
It is not in the centre between the previous holes but slightly aside, 97mm with respect to the
vertical of the left hole, and 65mm with respect to the vertical of the right hole.
•
The wall must be robust, flat, with no rough patches, in a rigid fire-proof and heat-resistant
material, with a suitable thickness to ensure that the appliance is fixed securely, bearing in mind
that it can be oriented in various directions and therefore the wall must withstand a certain stress.
•
The appliance must be fixed using the appropriate holes and secured using the metal plate
supplied with all the other screws and dowels. Fastening must be solid and secure.
•
The appliance must be turned so that air is blown downwards and not upwards.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
9
28
/
Assembly page 9/28
Publicité
