Publicité
Translation of the original instructions
USING THE DC CHARGING ADAPTER
1.Put the light vertically into the base. Plug the adapter's jack plug into the socket of the base.
2.Plug the adapter into the vehicles 12V DC cigarette lighter or accessory power socket.
3.The 3 charging indicator lamp will glow RED while charging is in process.
4. The battery will be fully charged after approximately 4-6 hours, and 3 RED charging indicator will be turned to
GREEN when the unit is fully charged.
5.Disconnect the jack plug from the light, and remove the DC adapter from the outlet socket.
BATTERY REPLACEMENT (3*3.6V 300MAH NI-MH)
NOTE : FOR SAFETY'S SAKE, THE USER IS NOT ADVICED TO CHANGE THE BATTERY BY HIMSELF OR
HERSELF. PLEASE ASK A PROFESSIONAL FOR HELP.
1. Detach the 3 LED Flashlights by removing the flashlight 1 away from flashlight 2. Hold the flashlight 1 and 2 firmly
and pry open the assembly by twisting action shown in Fig.1.
2. Detach the flashlight 2 and 3 by repeating the step 1 above for the flashlight 2 and 3.
3. Remove the battery compartment cover by sliding it away from the flashlight body.
4. Install (9pcs NI-MH batteries, each 1.2V 300mAH) batteries following the orientations of batteries shown on the
flashlight housing into the battery compartment. Insert the Negative (-) terminal of batteries toward the LED pivo-
tal head direction
5. Replace the battery compartment cover back into the designated location and snap to engage securely.
6. Repeat steps 3 through 5 for other flashlights
Replace the battery according to the following illustrations :
CARE AND MAINTENANCE STORAGE
Store the work light and charging adapters in a clean and dry area. Be sure to keep the charging adapters supplied
with this product stored separately from similar items as only charging adapters included with this light are compa-
tible. Using a non-compatible charger could cause damage to the light or personal injury.
The light may also be stored in a vehicle for use in roadside emergencies. To prevent the light and any of the accesso-
ries being damaged, please ensure that it is properly secure and in a safe place inside the vehicle.
CLEANING
All exterior surfaces of the work light can be wiped clean with soft cloth dampened with a soap and water solution.
Do not immerse or submerge any part of light in water or any other solvent. Never use solvents or cleaning agents
containing petroleum (petrol, kerosene, oil), paint thinner, turpentine, alcohol, or ammonia. Harsh materials like these
can damage surfaces.
MAINTENANCE
Only qualified service personnel must perform repairs. Do not open the exterior casing of the work light as there are
no user serviceable parts inside. Opening or visible attempts to open or repair a light may void any guarantee and / or
cause damage to the product or personal injury.
This product contains an internal nickel-metal hybrid battery pack formulated from environmental-
ly sensitive materials. This product must be disposed of properly, with due care for the environment.
Please return this product to your local dealer or to your local recycling station, where batteries will be
recycled or disposed of properly.
All manuals and user guides at all-guides.com
LAMP LED COB 3 X 1W / 250 LUMENS
RECHARGEABLE
EN
7
Publicité
