Télécharger Imprimer la page

Toparc LED COB 3 x 1W Mode D'emploi page 6

Publicité

All manuals and user guides at all-guides.com
Translation of the original instructions
LAMP LED COB 3 X 1W / 250 LUMENS
EN
RECHARGEABLE
OPERATING INSTRUCTIONS
NOTE: Each LED flashlight is equipped with the dedicated ON/OFF Push Button and can be operated
independently without being assembled with other LED flashlights.
LED HIGH MODE: Press the ON/OFF switch, the work light will turn on. In this mode the work light operates as a
maximum illumination. Working time in this mode is up to 1 hour on a full charge.
LED LOW MODE: Press the ON/OFF switch one more time, the work light will turn on with a low light mode, working
time in this mode is up to 3 hours on a full charge.
LED WARNING MODE: Press the ON/OFF switch again, the LED light will blinking with warning light mode.
Press the ON/OFF switch one more time, the light will turn off.
IMPORTANT NOTE: Always turn the switch to OFF the light when the work light is not being used or
during storage.
CHARGING INSTRUCTIONS
This 3 in 1 rechargeable led work light must be fully charged before being used for the first time as
soon as taken from the package. The battery should be recharged every three months.
This will ensure that the battery gives its best performance now and on future re-charging cycles. The AC and DC
charging adapters are for re-charging the battery only. They can not be used to directly power the light. Always en-
sure the light is switched off while charging.
IMPORTANT NOTE : USE THE SUPPLIED CHARGER ONLY, OTHER CHARGERS MAY CAUSE THE DAMAGE
TO THE UNIT.
USING THE AC CHARGING ADAPTER
1. Put the light vertically into the base. Plug the adapter's jack plug into the socket of the base.
2. Plug the adapter into a 120V socket and switch the socket on(if applicable).
3. The 3 charge LED indicators will glow RED while charging is in progress.
4. The battery will be fully charged after approximately 4-6 hours, and 3 RED charging indicator will be turned to
GREEN when the unit is fully charged.
5. Disconnect the jack plug from the light, remove the adapter from the wall socket or switch off.
TO PREVENT OVERHEATING DO NOT CHARGE FOR MORE THAN 8 HOURS.
SAFETY PRECAUTIONS
Use provided charging adapter indoors in a dry location only. Exposure to damp or wet conditions could cause electro-
cution or damage to adapter.
Do not use the charger in the vicinity of flammable liquids or materials.
Store in dry location and do not allow the charging adapter to come in contact with water, rain or snow.
If the charging adapter comes into contact with water, place in a dry location at room temperature, on a soft ab-
sorbent towel and allow to dry thoroughly.
Do not operate the unit until it is completely free of moisture.
Use only the AC charging adapter supplied with light. Do not attempt to charge the light with an adapter that is not
compatible as this could result in a fire, damage to the light or personal injury.
6

Publicité

loading