Publicité
flash to let you know it is on. Press the touchpad 3 times to select your voltage. Once you have your voltage
selected press and hold the touchpad and you will hear the pump activate and see the vapor start filling the lower
bubbler cup. Once the lower bubbler cup is filled, cover the carb hole, pull the bubbler cup off the base, and inhale
through the top.
Note: The Sipper works with most cartridges but not all cartridges.
AUTO MODE
Alternatively, you can press the touchpad 2 times to start the auto filling mode. The Sipper will run for 1 minute
continuously. Once you see the bubbler cup is full press the touchpad 1 time to stop the auto mode. Depending on
the cartridge your lower bubbler cup may fill before the 1 minute is up.
Pro tip: This mode may be able to clear small clogs that could occur in the cartridge or atomizer. If it takes more
than 20 seconds, disable Auto Mode and use the included dab tool as a poker to manually clear the clog.
CLEANING
Take apart the unit completely for cleaning. First, remove airflow valve and separate the two pieces. Next, remove
the atomizer/cartridge cover from the base of the unit and remove the airflow silicone. Lastly, remove the atomizer
or cartridge from the 510 connection, and unscrew 510 connection from the base.
Glass: Wipe the lower bubbler cup with an alcohol wipe until all the residue has been removed. For the upper bubbler
cup, pour 91% alcohol or glass cleaner in the top and let it sit until all the residue has been dissolved. Alternatively,
you could put the entire bubbler cup into 91% alcohol or glass cleaner and wait till the residue is dissolved.
Silicone Parts, 510 Connection, Base: Use an alcohol wipe or a cotton swab and 91% alcohol to clean off the build
up on all of the silicone parts and 510 connection. Use a cotton swab and 91% alcohol to clean any buildup beneath
the 510 connection.
TROUBLESHOOTING
Dead Coil / No Connection: When the coil burns out or is not making a proper connection the light will flash red 3
times. Try removing and reinstalling the wax atomizer to reset connection. Otherwise, replace with a new wax
atomizer.
Low Battery Indicator: When the battery is less than 5% the light will flash red 8 times and the Sipper will power off.
Use the USB-C charging cable to recharge the Sipper until the touchpad light turns green.
WARNINGS
Do not expose to extreme temperatures or direct sunlight. Do not drop the device or accessories. Do not drop or
submerge in any liquid. Do not modify the electronics in any way. This device is intended for adults only. Do not
sell or provide to minors. Keep all parts, concentrates, herbs, and liquids away from children and pets. This is not
a medical device and is not intended to diagnose, treat, mitigate, cure, or prevent any ailment, disease, or other
conditions. Consult a physician before use, especially if you suffer from heart disease or any other medical
condition, or if you are pregnant or breastfeeding. Failure to follow any of these instructions could result in
product damage, property damage, personal injury, and may void warranty. Visit
information.
PAGE 2
INSTRUCTION
MANUAL
PulsarShop.com
PulsarShop.com
for warranty
PU-0357-21
Publicité
