Publicité
REMOTE CONTROL
Power
The Power Button turns the fireplace ON and OFF.
Heater
The Heater Button turns the heat ON and OFF.
Press "+" or "-" button to setting the temperature.
Flame
The Flame Button turns the flames ON and OFF.
Press "+" or "-" button to setting the flame color.
Timer
The Timer Button turns the timer ON and OFF.
Press "+" or "-" button to setting the timer.
Brightness
(Remote Control Only Function)
The Brightness Button adjusts the brightness of the flame and ember bed.
The display will show 1 to 5 for the flame effect brightness setting.
Speed
(Remote Control Only Function)
The Speed Button is used to adjust the flame speed.
The display will show P1 to P5 for the flame speed setting.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
14
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
CIRCUIT DIAGRAM
MOTOR
UPLIGHT
FLAME
NTC CONNECTOR
KEY CONNECTOR
RECEIVER
L INPUT
GND
N INPUT
FAN
TEMPERATURE CUT
HEATER
15
Publicité
