Publicité
GB
OPERATION
Display symbols
Indicator in charging mode
ͳ The charging icon (9) lights up.
ͳ The „low" (8) battery charge level lights up: The charge level
is 1%-30%.
ͳ The „low" (8) and „high" (7) battery charge levels light up:
The charge level is 30%-100%.
ͳ Once the battery is fully charged, the charging icon (9) goes
out and both battery charge levels (8,7) continue to be lit.
Indicator during use
ͳ The „low" (8) and „high" (7) battery charge levels light up:
The charge level is 100%-30%.
ͳ The „low" (8) battery charge level lights up: The charge level
is 30%-5%.
ͳ The charging icon (9) lights up: The charge level is below 5%.
Speed
The rpm is adjustable in 500 increments in the range between
5,000 and 6,000 by the +/- button (17). The smart rpm control
enables operating HairMaster®TRIMMER with the same
rotation speed irrespective of hair structure.
Instructions for using the comb attachment
Hold the comb attachment on both sides as shown in the figure
and insert it into the locking slot. (If fitted correctly, the comb
attachment is held firmly in place and cannot fall off.)
To remove the comb attachment, press the side of the comb
attachment with your thumb to unlock it as shown in the figure.
15
Please note:
Please exercise care with the sharp
blades when trimming or cutting
hair close to the ears. Protect the
7
ear against injury by holding your
hand over it before cutting.
8
DANGER! MORTAL DANGER DUE TO
9
ELECTRIC SHOCK!
CLEANING, CARE, STORAGE
Maintenance and lubrication of the device is required. For
correct operation of the device, always keep it clean.
– Disconnect the device from the power by unplugging it and
let it cool down before cleaning it.
– Keep the cable and power plug clean at all times.
– DANGER! Never dip the device in water or other liquids for
cleaning.
– Do not clean the device by rinsing it in water.
– Do not take the HairMaster®CLIPPER apart or attempt to
repair it.
– Clean the housing with a soft, slightly moistened cloth. Do
not use a harsh cleaning agent, as this can cause damage to
the surface.
Cleaning instructions
To remove the cutting head, slide it backwards, as shown in the
picture above.
Apply 2 or 3 oil drops on the blade as shown in the figure. A
clear sound can be heard during operation if the cutting head is
correctly positioned.
Publicité
