Publicité
8.3
Using the device
Never move the brush across tile, wood, plastic or other flooring material. The
brushes could scratch or damage the surface.
Operate the device at walking speed
The arrow
8.4
Selecting the proper brush
For information on replacing the brush, please refer to the "assembly" instruction section
Steel Brush: select this brush for removing persistent lichenics and moss on robust grounds
Use the steel brush on robust surfaces only (road, pavement) as it may
damage and/or scratch the ground.
Nylon brush: select this brush for removing weed, lichenics and moss from non-robust
surfaces.
8.5
Practical tips
▪
Always inspect the brush before starting the device. Never use damaged brushes.
Replace any damaged or worn brush.
▪
Use original brushes only.
▪
Never operate the device in rain or on wet ground. Operating the device in rain or on wet
ground can cause an electric shock.
▪
Always move across the slope when working on hills.
▪
Avoid any contact with fixed obstacles (rocks, walls, picket fences, etc.) in order to
prevent damages to the device.
▪
Switch off the device during breaks or when transporting it and wait until the brush has
completely stopped rotating.
9
TECHNICAL DATA
Rated voltage
Rated frequency
Rated power
No load speed
Brush size
10
NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is over 85 dB(A).
aw (Vibration)
Copyright © 2024 VARO
on the brush box indicates the brush's rotational direction.
POWXG6650
230 - 240 V
50 Hz
400 W
2000 min
110 mm
81 dB (A)
98 dB (A)
2,7 m/s²
P a g e
| 7
-1
K = 1.5 m/s²
www.varo.com
EN
Publicité
