4. Leave the door open to prevent
unpleasant smells.
When the appliance is not in use due to
power failure:
• Most power failures are corrected within a
few hours and don't affect the temperature
9. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
9.1 What to do if...
Problem
The appliance does not operate.
The compressor operates continual‐
ly.
The light does not work.
Too much vibration.
The appliance is noisy.
• If the power is going to be off for a longer
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
There is no voltage in the mains
socket.
The circuit breaker tripped or a
blown fuse.
Temperature is set incorrectly.
The room temperature is too high. Refer to the "Installation" chapter.
The door is opened too often.
The door is not closed correctly.
The light is turned off.
The appliance is not plugged in.
The circuit breaker tripped or a
blown fuse.
The lamp is defective.
The light button is not operating.
The appliance is not supported
properly.
The appliance is not supported
properly.
of your appliance if you minimize the door
opening.
time, you need to take the proper steps
described above.
Solution
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appliance
to the mains socket, to check if elec‐
tricity is flowing. If not, contact a quali‐
fied electrician.
Turn on the circuit breaker or change
the fuse.
Refer to the "Operation" chapter.
Do not keep the door open longer than
necessary.
Refer to the "Closing the door" section.
Turn on the light. Refer to the "Light
setup" section.
Connect the appliance.
Turn on the circuit breaker or change
the fuse.
Contact the Authorised Service Cen‐
tre.
Contact the Authorised Service Cen‐
tre.
Check if the appliance stands stable.
Check if the appliance stands stable.
ENGLISH
67