Télécharger Imprimer la page

AEG NSW8S826GT Notice D'utilisation page 62

Publicité

• 2A door open - lights on at the highest
dimming level, door closed - lights on at
the selected dimming level,
• 3A door open and closed - lights on at the
selected dimming level,
• 4A door open - lights on at the selected
dimming level, door closed - lights on at
the highest dimming level.
Light brightness (L):
• 9L is the brightest setting while 1L is the
dimmest one.
5.6 Cellaring
In this mode, the appliance switches to the
preset default temperature of 12°C.
To activate the Cellaring mode, tap the Cellar
Mode key. CE on the display starts blinking.
Wait 5 seconds. The mode is active when CE
stops blinking and is lit at half brightness.
To deactivate the Cellaring mode, tap Cellar
Mode once again. When the Cellaring mode
is deactivated, the temperature returns to its
previous setting.
5.7 Child Lock mode
Activate the Child Lock mode to lock the keys
from an unintentional operation.
To activate the Child Lock, tap and hold the
Cellar Mode key for 3 seconds. When the
mode is on, the lock indicator lights up at full
brightness. After 3 seconds, the lock indicator
dims to half brightness.
If you press any key other than Cellar
Mode, the lock indicator blinks three
times.
To deactivate the Child Lock mode, tap the
corresponding key again.
The Child Lock mode deactivates after
electricity interruption or unplugging the
appliance.
5.8 Reset air filter
To reset the air filter alarm:
62
ENGLISH
1. Change the carbon air filter. Refer to the
"Replacing air filter" section.
2. Tap and hold the Temperature increase
and Light keys simultaneously for 5
seconds.
3. The filter indicator turns off for the next 6
months.
After 6 months, the display shows the
filter indicator to remind you to replace
filter.
5.9 Mute or unmute sounds
The sounds are enabled by default.
To mute or unmute the sounds:
1. Tap and hold the Cellar Mode and
Temperature increase keys
simultaneously for 5 seconds.
2. The display shows Of for 2 seconds when
the sounds are muted, or On for 2
seconds when the sounds are unmuted.
5.10 Changing temperature units
To switch the temperature units between °C
and °F:
1. Tap simultaneously the Cellar Mode and
Temperature decrease keys.
2. Once you set your preferable unit, °C or
°F blinks on the display for 5 seconds.
5.11 Demo mode
Activate the Demo mode to demonstrate the
appliance's features.
To activate the Demo mode, tap and hold the
Light and Cellar Mode keys simultaneously
for 10 seconds.
Once the mode is on, the display shows dE
and On blinking alternately for 5 seconds.
The above message is displayed every 5
minutes to remind you that the appliance is in
the Demo mode.
To deactivate the Demo mode, repeat the
above procedure.
Once you deactivate the mode, the display
shows dE and Of blinking alternately for 5
seconds.

Publicité

loading