POLTI SANISYSTEM BUSINESS Entretien Et Depannage page 3

EN EN
PROBLEM
The appliance does not turn
on.
The "steam ready" indicator
light and the steam
dispenser light come on and
go off during use.
No steam is coming out.
Steam does not come out
and the cap won't unscrew.
The appliance is pressurized
but little steam comes out.
During use the appliance
does not consume Polti
HPMed.
If problems persist or are not listed above, please contact a Polti Authorised Service Centre
(see www.polti.com for the updated list) or contact Customer Services.
TROUBLESHOOTING TROUBLESHOOTING
POSSIBLE CAUSE
No power.
This indicates that the
electrical resistor has started
to work to keep the pressure
constant.
Boiler out of water.
The boiler is not yet
pressurised.
The steam dispenser is not
inserted correctly.
Child safety inserted.
Steam button broken.
The steam is set to the
Minimum level.
The stopper inside the
bottle has not been inserted
correctly.
3
SOLUTION
Check that the product
has been connected to
the mains, as indicated in
Section 1.
It is a normal phenomenon,
no action is necessary.
Add water to the tank as
described in Section 5.
Wait until the steam
indicator light comes on.
Insert the steam dispenser
correctly all the way down.
Deactivate the safety switch.
Do not try to open the
cap. Take the device to an
Authorised Service Centre.
Turn the steam adjustment
knob to increase the flow.
Insert the stopper correctly,
following the instructions in
Section 1.