Publicité
EMC ACCOMPANYING DOCUMENT
The Via Nano 6 requires special precautions regarding EMC and needs to be installed and put into service according to the EMC information
provided in these accompanying documents.
WARNING: Portable RF communications equipment (including peripherals such as antenna cables and external antennas) should be used no
closer than 30 cm (12 inches) to any part of the Via Nano 6, including cables specified by the manufacturer. Otherwise, degradation of the
performance of this equipment could result.
WARNING: A risk of increased emissions or decreased immunity may result if any additional cables are attached.
WARNING: This device has not been tested for compatibility with all other potential RF Emitters such as X-ray, Metal Detectors,
Electrosurgical Equipment, Diathermy Equipment, 5G Cellular, NFC, WPT, or Electronic Article Surveillance (EAS) devices. Caution should be
used if such emitters are present within the use environment.
WARNING: Use of this equipment adjacent to or stacked with other equipment should be avoided because it could result in improper
operation. If such use is necessary, this equipment and the other equipment should be observed to verify that they are operating normally.
WARNING: Use of accessories, transducers, and cables other than those specified or provided by the manufacturer of this equipment could
result in increased electromagnetic emissions or decreased electromagnetic immunity of this equipment and result in improper operation.
Guidance and manufacturer's declaration – electromagnetic emissions
The Via Nano 6 is intended for use in the electromagnetic environment specified below. The customer or the user of the Via Nano 6
should ensure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage Fluctuations
IEC 61000-3-3
Manuel Via Nano 6.1
Compliance
Group 1
Class B
Class A
Complies
Electromagnetic environment - guidance
The Via Nano 6 uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to cause
any interference in nearby electronic equipment.
The Via Nano 6 is suitable for use in all establishments, including
domestic establishments and those directly connected to the public
low-voltage power supply network that supplies buildings used for
domestic purposes.
24
Publicité
