Publicité
User manual
2. Install and setup.
* Check power is OFF, Check output Nozzle is EMPTY or clean it.
* Check DMX IS NOT PLUGGED !!
* Connect the power cable using a grounded plug.
* Switch power On and Open the magnetic hinged lid
* Swipe the Consumable ID card that come with the Spark Seed pouch
(2020) within 10 seconds after switching On, Go Off and back On if
needed.
* Successfully swiping card make LCD showing the pouch informations,
Then the identified Spark Seed could be filled into the fixture
* Fill the consumable into the feed port, NEVER into the output nozzle !!
* Close the lid securely after filling.
* Eventually connect the DMX and beware of
Any activation.
Feed Port
Output Nozzle
Handle
Air Inlet
Breaker
Power Switch
Power Inlet
* Statup menu will show « HEATING », at this point the machine is preparing itself for operating.
* When « Ready to Work » is displayed, the startup is finished and operating can be launched.
* Manual and DMX modes are available through LCD menu. In manual mode you can choose to set OFF
the heating if the machine is not supposed to be used for some time but if you need/prefer to keep
power ON.
* To operate in Manual, just set « Manual Fountain » ON; Beware no to be in front of the output nozzle
and stay ready to retreat, after 5 seconds, the display will show « Working ».
*Settings allows to choose :
-
Fountain Height from 1 to 10m
-
DMX Address from 1 to 511
-
Surplus Time / No Time if no more time remaining.
Press MENU repeatedly until you reach the needed menu.
* In both DMX and Manual modes, after 30sec continuous output which is the maximum timing, the
display will show back on « Heating » and then « Ready », else shows « Working ».
Storage Bin Lid
Feed Port
Output Nozzle
Air Outlet
Control Panel
Card Swipe Zone
3-pin DMX Socket
5-pin DMX Socket
Power Outlet
V-1 Spark Machine
11
Publicité
