Publicité
Installation (continued)
3
Attaching the mixer to the
standpipe
NOTE: Do not reverse the hot and cold supply.
□
Attach the mixer (C) to the standpipe (D), making
sure the prongs (1) on the standpipe (D) insert
into the hole (2) of the mixer (C).
□
Install the set screw (K) and tighten into the
standpipe (D) with Hex wrench (Hex: 2.5mm, J).
Front
1
Cold inlet
supply line
All manuals and user guides at all-guides.com
2
C
J
K
D
Hot inlet
supply line
4
Drilling the holes & Making the
waterline connections
□
Mark the locations for the screws with a pencil
(1). With an electric drill (2), drill three 1/4 in.
diameter holes for the screws in the oor.
Place the anchors (G) into the holes.
□
Connect the exible supply lines (3) to the water
supplies (4).
1
1
3
4
5
Please contact 1-855-HD-GLACIER for further assistance.
6mm dia.
G
3
Floor
4
HOMEDEPOT.COM
2
Floor
Publicité
