Publicité
1
Preface and general information
About these Operating Instructions
1
Preface and general information
This EPM-H312 operating unit enables you to access codes of Lenze controllers and
to control them easily. Communication takes places via the system bus (CAN).
By means of the Lenze software »HMI Designer« the programming of the operating
unit is easily achieved.
1.1
About these Operating Instructions
These Operating Instructions describe safe and trouble-free working on and
ƒ
with the EPM-H312 operating unit.
All persons working on and with the EPM-H312 operating unit must have
ƒ
these Operating Instructions available and observe all relevant information
and notes.
These Operating Instructions must always be kept as a complete document
ƒ
and in a readable state.
1.2
Terminology used
Term
Drive controller
HMI
1.3
Scope of supply
Quantity
1 operating unit EPM-H312
ope at g u t
1 Operating Instructions
2 mounting clamps
2 mounting clamps
2 screws M4 × 35 mm
2 screws M4 × 35 mm
1 seal
1 seal
1 4-pole terminal strip for connection of DC
voltage supply
voltage supply
1 terminal strip 5 pol. for system bus (CAN)
1 terminal strip 5 pol. for system bus (CAN)
connection
38
Used in this text for
Lenze frequency inverter 8200 vector and 9300 vector, servo inverter
9300 and 9400
Human Machine Interface
Important
3
After receipt of the delivery, check immediately whether
te ece pt o t e de e y, c ec
the items delivered match the accompanying papers.
th it
Lenze does not accept any liability for deficiencies
Lenze does not accept any liability for deficiencies
claimed subsequently.
claimed subsequently.
Claim
visible transport damage immediately to the
visible transport damage immediately to the
forwarder.
forwarder.
visible deficiencies/incompleteness immediately to
visible deficiencies/incompleteness immediately to
your Lenze representative.
d li
d
t h th
i
EDBPM-H312 DE/EN/FR 2.0
ed ate y
et e
i
Publicité
