Publicité
Use as a phono preamplifier
• Connect the output of your record player to the PHONO IN connector on the phono preampli-
fier.
If your record player has a ground terminal (usually a metal screw terminal or a thin
ground wire), connect this terminal with the screw terminal next to the PHONO IN
connector.
• Slide the MM/MC switch in the correct position according to the cartridge used:
MM = Moving Magnet-System / MC = Moving Coil System
• Slide the LINE IN/PRE-AMP OUT switch in the PRE-AMP OUT position.
• Connect the LINE IN/PRE-AMP OUT port to an available input on your audio amplifier. If
your audio amplifier does not have an appropriate connection socket, use a suitable adapter
cable.
• Connect the USB connector on the phono preamplifier with an availablr USB port on your
computer. Alternatively, a power supply with USB output can be connected.
• Select the audio amplifier on the input to which the phono preamplifier is connected and start
playback on the record player.
When a computer is connected to the USB port, the signal of the record player can
be digitized simultaneously (see "digitization of records").
Digitizing of line signals
• Connect the output of your device with the line output (e.g. CD player) to the LINE IN/PRE-
AMP OUT connector. If your device does not have an appropriate connection socket, use a
suitable adapter cable.
• The position of the MM/MC switch is not relevant in this particular usage.
• Slide the LINE IN/PRE-AMP OUT switch in the LINE IN position.
• Connect the USB connector on the phono preamplifier with an available USB port on your
computer.
• The computer recognizes the phono preamplifier automatically and install the required drivers.
• Start your digitizing software and set the source "USB PREAMP" one.
• Begin the playback on CD-Player.
Handling
• Do not use the phono preamplifier with damaged housing or missing covers.
• Never use the product immediately after it has been brought from a cold room into a warm
one. The condensation that forms might damage the product. Leave it until it has reached
room temperature. Wait until the condensation has evaporated.
Maintenance and Care
The product does not have to be serviced and, except for occasional cleaning with a soft, dry
cloth, requires no maintenance whatsoever.
Never use aggressive cleaning agents or chemical solutions as these may damage the sur-
faces.
Disposal
Electronic devices are recyclables and must not be disposed of in the household
waste!
When it is no longer of use, please dispose of the product according to the current
statutory requirements.
Technical Data
Operating voltage ................ 5 V/DC (via USB)
Current consumption ............ approx. 4 mA
Frequency response ............. 30-20000 Hz
Distortion factor .................... 0.03%
Equalization .......................... RIAA curve
Suitable cartridge .................. MM or MC system
Audio sample rate ................. up to 48 kHz
Operating system ................ WIN2000 or higher / Mac OSX
Dimensions ........................... 129 x 32 x 76 mm
Weight .................................. 110 g
.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright 2014 by Conrad Electronic SE.
Publicité
