Publicité
EN
EN
Note : The flange of the loudspeaker is designed to flex and conform to any small
imperfections in the wall surface. Tighten the 4 screws on the front of the baffle only
enough to make the flange become snug against the ceiling or wall. As you tighten
the screws, the feet will automatically flip into an outward position, there by clamping
the dry wall between the feet and the flange. Once the loudspeaker is perfectly in
place, tighten it firmly.
Caution : Over-tightening may warp the baffle, crack the wall, cause the flange to
WARNING
distort, and make the grille difficult to install.
Avoid applying pressure to the tweeter, as it is particularly delicate, and such an
action could damage definitively the tweeter.
4. Secure the grille into place.
Note : The loudspeaker flange incorporates high strength magnets to secure the grille
into place. Simply line the grille with the loudspeaker flange.
V. PAINTING INSTRUCTIONS
The grilles can be painted. However, great care should be taken not to clog the holes,
as this will severely reduce the sound quality of the loudspeakers.
If you plan to paint your grilles, it should be done before the installation. The scrim
cloth backing must be removed prior to painting the grilles. The surface should be
cleaned with a light solvent to remove any dust or residue. Elipson recommends a light
spray-painting using 5 parts thinning agent to 1 part paint. Put the scrim cloth back on
the grille. Do not paint the grille while they are attached to the loudspeaker.
40
41
Publicité
