Télécharger Imprimer la page

Fantini Rubinetti NICE S104SWU Instructions De Montage page 5

Publicité

INSTALLATION
- INSTALLATION - INSTALACIÓN
EN
INSTALLING THE FLEXIBLE HOSES (SUP-
PLIED): warning
Only use the flexible hoses supplied. Check for the
presence and perfect condition of the seaming on
either side of the flexible hoses before installation.
Screw on the connectors with an OR seal by hand
(maximum tightening torque of 3 Nm). Screw on
the connectors with a gasket seal (nuts) by hand
and next tighten by a quarter of a turn with an
appropriate spanner. Prolonged contact with sub-
stances, even blandly aggressive, may damage the
braid and consequently cause the flexible hose to
be damaged. Do not connect the electrical system
earthing to the flexible hose or to another plumb-
ing pipe. Replace the flexible hose in the event of
small leaks. We recommend the installation of un-
derbasin filters.
INSTALLATION DES FLEXIBLES (FOUR-
FR
NIS) : recommandations
N'utiliser que les flexibles fournis. Avant l'installa-
tion, contrôler que les agrafes des flexibles soient
présentes et intactes des deux côtés. Visser les rac-
cords avec joint d' é tanchéité O.R. à la main (couple
de serrage maximum 3 Nm). Visser les raccords
avec joint d' é tanchéité (écrous) à la main, plus un
1/4 de tour avec une clé appropriée. Le contact
prolongé avec des substances, même si peu agres-
sives, peut endommager la tresse avec consé-
quente rupture du flexible. Ne pas raccorder la mise
à la terre de l'installation au flexible ou à une autre
conduite hydraulique. Remplacer le flexible en cas
de petites pertes.
L'installation de robinets sous lavabo avec filtre est
conseillée.
INSTALACIÓN DE LOS FLEXOS (INCLUIDOS): advertencias
ES
Utilice únicamente los flexos incluidos. Antes de la instalación, comprobar que las conexiones de los flexos estén
tengan sus juntas en los dos extremos y en buen estado. Enroscar a mano los racords con junta tórica (máximo par de
apriete: 3 Nm). Enroscar los racords con junta (tuercas), antes a mano y luego 1/4 de vuelta con una llave adecuada. El
contacto prolongado con sustancias mínimamente agresivas puede estropear el trenzado y, por lo tanto, provocar que se
dañe el flexo. No conectar la toma de tierra de la instalación eléctrica al flexo o a otros conductos de agua.Cambiar el flexo
si se detectan pequeñas pérdidas. Se recomienda instalar llaves de paso con filtro bajo el fregadero.
DIN6 = 25mm - 1"
DIN8 = 30mm - 1 1/8"
1
DIN10 = 35mm -
3/8"
1
DIN13 = 45mm -
3/4"
OK
ø x 2
OK
5

Publicité

loading

Ce manuel est également adapté pour:

Nice s210sbuNice s213sbu