nissen BakoLight LED/S GPS/2 Notice D'utilisation page 20

Low voltage indication
If the voltage of the battery sinks below 4 volt, the lamp blinks every 2 seconds (normally every se-
cond) for minimum 16 hours.
Others
Function of the LED on the circuit board:
The LED has several monitoring functions. When switching on the pulser the function of the position
switch can be checked. The LED blinks according to the position of the switch (once for position 1, twi-
ce for position 2, tenfold for position 0 etc.).
At normal blinking light operation the synchronisation by the GPS signal is indicated. When LED and
lamp are blinking together it is synchronous. When the LED stays dark the lamp is not synchronous.
Removal of the circuit board
• Remove the lens.
• Disconnect the connections of the screw clamp and take out 4 screws of the circuit board.
• Take out the circuit board.
CAUTION!
2.4 Mounting
Mounting on beacons and safety barriers:
• Lower the security screw on the side.
• Mount on beacon or similar.
• Fasten and save the BakoLight by turning the security screw.
Mounting of BakoLight with firmly mounted bracket:
• Click back the strap click to lay the clip on the thumb or tube.
• Click over the clip and fasten the nuts with the NiKo-key.
Mounting of BakoLight with firmly mounted bracket on safe-
ty barriers:
• Remove the screw with the NiKo-key.
• Push the lamp including bracket under the edge of the safety
barrier.
• BakoLight with firmly mounted bracket can be fastened on the
barrier.
20
Disconnect the battery before removing the circuit board!
BakoLight LED/S GPS/2
© 2017 Adolf Nissen Elektrobau GmbH + Co. KG
ENGLISH