rather than from a gasoline dispenser nozzle.
f) Keep nozzle in contact with the rim of the fuel tank or
container opening at all times, until refueling is complete.
Do not use a nozzle lock-open device.
g) Replace gasoline cap securely and wipe up spilled fuel.
h) if fuel is spilled on clothing, change clothing immediately.
Operation
1. Do not put hands or feet near rotating parts, in the auger/
impeller housing or chute assembly. Contact with the rotating
parts can amputate hands and feet.
2. Always aware of traffic when operating along streets or
curbs.
3. The auger/impeller control lever is a safety device. Never
bypass its operation. Doing so makes the machine unsafe and
may cause personal injury.
4. The control levers must operate easily in both directions
and automatically return to the disengaged position when
released.
5. Never operate with a missing or damaged chute assembly.
Keep all safety devices in place and working.
6. Never run an engine indoors or in a poorly ventilated area.
Engine exhaust contains carbon monoxide, an odorless and
deadly gas.
7. Do not operate machine while under the influence of alcohol
or drugs.
8. Muffler and engine become hot and can cause a burn. Do
not touch. Keep children away.
9. Exercise extreme caution when operating on or crossing
gravel surfaces. Stay alert for hidden hazards or traffic.
10. Exercise caution when changing direction and while
operating on slopes.
11. Exercise extreme caution when operating on slopes. Do
not attempt to clear steep slopes.
12. Plan your snow-throwing pattern to avoid discharge
towards windows, walls, cars etc. Thus, avoiding possible
property damage or personal injury caused by a ricochet.
13. Never direct discharge at children, bystanders and pets or
allow anyone in front of the machine.
14. Do not overload machine capacity by attempting to clear
snow at too fast of a rate.
15. Never operate this machine without good visibility or light.
Always be sure of your footing and keep a firm hold on the
handles. Walk, never run.
16. Disengage power to the auger/impeller when transporting
or not in use.
17. Never operate machine at high transport speeds on
slippery surfaces. Look down and behind and use care when
backing up.
18. if the machine should start to vibrate abnormally, stop
the engine, disconnect the spark plug wire and ground it
against the engine. Inspect thoroughly for damage. Repair any
damage before starting and operating.
5