Publicité
Electrical Considerations
All wiring should be done by a qualified electrician and shall be
in compliance with all local, city and state building codes. Before
making the electrical connection, make sure that the main power
supply is disconnected. The fireplace, when installed, must be
electrically grounded in accordance with local codes, or in the
absence of local codes, with the National Electrical Code ANSI/
NFPA 70 (Latest Edition).
A factory installed junction box is located on the lower right side
of the fireplace. The junction box and wiring may be relocated to
the opposite side of the fireplace if desired. Wiring to the junction
box must be metal clad or enclosed in a conduit and must be
approved for outdoor use. Connect the wiring to an external GFI
protected outlet installed near the fireplace. See Figure 10.
35305-3-0317
PLANNING INSTALLATION
CAUTION
Figure 10
Page 11
Publicité
