Publicité
that the boiling cycle has started. When the water has boiled, the light
turns off and the kettle switches off. To switch the kettle off at any time,
press the stop button "O".
IMPORTANT:
• The kettle switches off automatically when the boiling cycle is complete.
• If the kettle is removed from its base before the boiling cycle is complete,
the kettle will switch off automatically.
• To switch the kettle off before the end of the boiling cycle, press the stop
button "O".
DO NOT open the lid when the kettle is hot.
If you want to use the kettle again, allow the safety thermal switch to
cool down for 60 seconds, then press the power button "I".
If the kettle is switched on by mistake when it is empty, the thermostat
will automatically perform an on/off cycle to prevent overheating. If
this situation occurs, press the stop button "O" and unplug the kettle
immediately. Allow the kettle to cool down before refilling it.
8. After use, put the kettle back on its base or on a heat-resistant surface.
9. Unplug the power cable when not in use.
ONE CUP DISPENSING MODE
1. Follow steps 1-6 in the "USING THE PRODUCT" section.
2. Place the drip tray in front of the water dispensing door (see fig.1).
3. Open the water dispensing door by pressing the button with the " ".
4. Place a cup on the drip tray. IMPORTANT NOTE: A cup must ALWAYS
be placed on the drip tray when the water dispensing door is
open.
5. Select the desired cup size by turning the knob around the power button
and press the power button "I".
6. When the water boils, it is automatically poured into the cup from the
water dispensing door and the kettle switches off.
IMPORTANT:
• The kettle switches off automatically when the boiling cycle is complete.
• To switch the kettle off before the end of the boiling cycle, press the stop
button.
19
EN
English
Publicité
