Publicité
Parts Identification
Electrical Safety
- This tool is double insulated. Therefore no earth wire is required.
- Always check that the power supply corresponds to the voltage on the rating
plate.
Assembly
Warning! Before assembly, make sure that the tool is switched off &
unplugged.
Use
Mounting the nozzle for blowing operations
·Insert the pin located inside the nozzle into the 4
notch provided on the blast port .
·To lock nozzle in place, turn the nozzle in the direction
indicated.
-To remove nozzle, turn the nozzle in the opposite direction.
Mounting the nozzle and dust bag for dust collection
·For dust collection, mount the dust bag at the blast port
and nozzle at the suction port .
·To remove Dust Bag and Nozzle, simply pull out by first
turning in the opposite direction.
A.
1. Nozzle
2. Blast Port
3. Trigger Switch
4. Lock-On Button
5. Plug
6. Suction Port
7. Carbon Brush
Fig. 1
Fig. 2
WWW.NIKOLAOUTOOLS.GR
Main Technical Data
Model
Rated Power Input
Rated Voltage - Frequency
Air Flow
No - Load Speed
Includes
BPB6600
500 Watt
220 - 240 V (~) - 50 Hz
2,8 m
/ min
3
13000 rpm
1 pc dust bag
EN
3
Publicité
