Outwell APPETIZER SELECT Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
1. PUT THE PAN SUPPORT CORRECTLY LIKE THE PICTURE
2. HOW TO INSTALL CARTRIDGE
• Open the cartridge cover.
Only use 220 g Butane cartridge which complies with EN 417
• Make sure ignition knob is in "OFF" position and cartridge
lever is in "RELEASE" position.
• If the ignition knob is not completely in "OFF" position,
the cartridge cannot be engaged into "LOCK" position.
• Place the cartridge into the compartment. Align the
cartridge properly by inserting the cartridge guide tab of
the unit into the cartridge slot on the rim of the canister.
• Lock in place by pushing the cartridge lever down to
"LOCK" position and then close the cartridge cover.
• Check that the cartridge is positioned properly, and
the cartridge lever is in the "LOCK" position.
• You can now turn on the unit.
CAUTION:
Incorrect positioning of the gas cartridge will
cause the burner to break and/or leak which will produce
hissing sound, and a smell of gas. In this case, please follow
the description in part "Procedures for Gas Leakage".
3. HOW TO IGNITE
Turn the ignition knob counter-clockwise until you hear
a 'click' sound.
• If the burner does not light, repeat the ignition procedure.
• Phenomenon of flaring may occur during warm up period
or if the appliance is moved. The flaring will stop within one
minute or when it's moving stops.
4. HOW TO CONTROL FLAME
The size of the flame can be regulated by turning the ignition
knob slowly toward "OFF" position from "ON" position.
5. HOW TO EXTINGUISH
Turn the ignition knob clockwise to "OFF" position. The flame
is automatically cut off and no gas will be supplied.
• The flame will be extinguished before the ignition
knob is turned completely to "OFF" position.
• Check to ensure the flame is extinguished.
6. HOW TO REMOVE BUTANE CARTRIDGE
Raise the cartridge lever up to the "RELEASE" position.
Open the cartridge cover and then take the cartridge out.
Ensure the ignition knob is at "OFF" position.
7. HOW TO BURN OFF REMAINING FUEL
Some fuel may remain in the gas cock after the unit has been turned off.
For your safety, with the cartridge lever in "RELEASE" position, turn ignition
knob to "ON" position to burn off any remaining fuel.
HOW TO USE
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

650669Ow-650797-m22

Table des Matières