Publicité
Welcome
Inserting Your Device:
Press the bottom half of your iPad
into the case and snap it snuggly into
place. Press the top half of your iPad into
the case and check each corner to make
sure your device is seated properly.
Slide the USB-C Direct Connect
piece into the USB-C port of your iPad.
Use the included screwdriver to
tighten the two tiny screws, securing the
Direct Connect piece in place.
Note: The Tough Keys case and keyboard is
meant to remain on your iPad for extended
use. Do not try to remove Tough Keys
from your iPad without first loosening the
screws and removing the Direct Connect
piece from the USB-C port on your iPad.
Removing Your Device:
Loosen the screws on the Direct Connect piece. Remove the Direct Connect
piece from the USB-C port on your iPad.
Hold on to the top lip of the case and press against the back of the case. Then,
grasp the exposed side of your iPad and lift/pull it away from the cover.
Turning On Tough Keys:
Once Tough Keys has been installed on your tablet, it automatically turns on
every time you activate your iPad. When you close your iPad, Tough Keys will
go into Sleep Mode.
Connectivity:
No Bluetooth® is required. Tough Keys uses USB-C Direct Connect to connect
with and transfer data directly to the iPad.
Charging:
Tough Keys draws its power directly from the iPad, so there are no batteries that
need to be recharged. We've included a USB-C cable for your convenience that
can be plugged into Tough Keys. That cable will channel power to your iPad if
it needs re-charging.
2
Publicité
