Franke FGB 906 IS Mode D'emploi Et Installation page 14

Activated Charcoal Filter (Recirculation Version)

It cannot be washed or regenerated, and must be changed when the FC symbol on the display

appears, or at least once every 4 months. The Alarm signal, if it has been activated, only

appears when the Suction motor is turned on.

Activating the alarm signal

• In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on

installation or at a later date.

• Turn the Lights and the Suction Motor off.

• Press D and hold for approximately 5 Seconds:

• The message FC+Dot flashes twice, A.C. Filter saturation alarm ACTIVATED

• The message FC+Dot flashes once, A.C. Filter saturation alarm DEACTIVATED

CHANGING THE ACTIVATED CHARCOAL FILTER

Resetting the alarm signal

• Turn the Lights and the Suction motor off, then disable the 24h

function, if enabled.

• Press button E (see the paragraph on Use).

Changing the Filter

• Open the Comfort panels by pulling on the recess.

• Remove the Metal grease filters.

• Remove the saturated charcoal filter by releasing the fixing

hooks.

• Fit the new filter and fasten it in its correct position.

• Replace the Metal grease filters.

• Close the Comfort panels.

• For replacement contact technical support ("To purchase

contact technical support").

Lighting unit