Publicité
Flue assembly - Mounting the hood body
• Position the upper chimney section and fix the upper part to
the frame using the 2 screws 12c (2,9 x 6,5) provided.
• Similarly, position the lower chimney section
lower part to the frame using the 2 screws 12c (2,9 x 6,5)
provided.
Before fixing the hood canopy to the frame:
• Screw the 2 screws 12f half way into the holes provided in
the sides of the bottom of the frame.
• Remove the grease filters from the hood canopy.
• Remove any activated charcoal filters.
• Lift the hood canopy and engage the screws 12f in the slots
(A) as far as they will go.
• Working from below, fix the hood canopy to the frame (B),
using the 4 screws 12q and 4 washers 22 provided, then
tighten all the screws securely.
ELECTRICAL CONNECTION
• Connect the hood to the mains through a two-pole switch
having a contact gap of at least 3 mm.
• Remove the grease filters (see paragraph Maintenance) being
sure that the connector of the feeding cable is correctly in-
serted in the socket placed on the side of the fan.
• Connect the control connector Cmd.
• Connect the lights connector Lux.
• For the recirculation version, fit the activated carbon odour
filter.
• Replace the grease filters.
EN
and fix the
1
11
Publicité
