Temperature Mode Settings - Gima YI-400 Manuel De L'utilisateur

Thermomètre à infrarouges sans contact
Masquer les pouces Voir aussi pour YI-400:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9
Display
1. Memory/Memory space number
2. Object temperature Mode
3. Body temperature Mode
4. Voice status
5. Laser
6. Low battery icon
7. Measurement unit
8. Temperature
Operation Instructions

Temperature Mode settings

• With the meter ON, press "3" button, for three seconds until to "F-1" shown
to enter the long term calibration drift correction mode. On entering the mode,
the previous temperature correction factor will appear on the display. To make
a correction, measure a known, fixed temperature source. Enter the correction
mode and press the + or - buttons to change the correction value and
minimize the difference in readings. Repeat and adjust the correction value as
needed until the measurement on the meter matches the known temperature.
The mode is applied to Body Temp.
• Press the "3" button a second time "F-2" shown to set the alarm temperature
limit. Press the+ or - buttons to change the value.
The mode is applied to Body Temp
• Press the "3" button a third time "F-3" shown to set the °C temperature units.
The temperature units °C or °F will be shown. Press the + or - buttons to
change the unit.
• Press the "3" button a forth time "F-4" shown to set the backlit status.
Press the + or - buttons to switch from ON to OFF.
• Press the "3" button a fifth time "F-5" shown to set the laser status.
Press the + or - buttons to switch from ON to OFF.
Notice: Only when the laser head installed.
1
2
3
ENGLISH
6
4
5
7
8

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

25591

Table des Matières