Functions And Controls - AudioSonic CD-570 Mode D'emploi

• Attention should be drawn to the environmental aspects of battery disposal.
SAFETY MECHANISM
• This unit incorporates a safety interlock mechanism that switches the laser beam
on and off, when the disc holder is open, the laser baser beam stops automatically.

FUNCTIONS AND CONTROLS

1. FUNCTION SELECTOR
2. AC POWER SUPPLY
3. SPEAKER
4. DISPLAY
5. FMSTEREO INDICATOR
6. USB JACK
1
7. BATTERY COMPARTMENT
8. TUNINg KNOB
9. HANDLE
2
10. VOLUME CONTROL
11. STEREO HEADPHONE JACK
12. MODE
13. PROgRAM/RESTART
14. FOLDER UP
15. FOLDER DOWN
16. TELESCOPIC ANTENNA
17. NExT
18. PLAY/PAUSE
11
10
19. BACK
20. STOP
21. CD DOOR
3
4
5
6
7
9
12
17
13
18
14
19
15
20
21
POWER SUPPLY
If you would like, the electrical power supply can be used to save the batteries. Make
sure that the unit is unplugged from the wall outlet before inserting the batteries.
USING THE DC POWER SUPPLY
Batteries (not included)
Open the battery compartment and insert 8 R14 batteries with respect to the "+" and
"-" polarity indications in the compartment.
Important:
When replacing the batteries, make sure you dispose of the old batteries in
accordance with applicable regulations. They should be disposed of in a location
8
specifically designated for that purpose so they can be recycled safely and without
posing any risk for the environment. Do not burn or bury them. Incorrect use
of the batteries may result in electrolyte leakage having a corrosive effect in the
compartment.
• Do not mix different types of batteries: do not use alkaline batteries with saline batteries,
for example. only use batteries of the type recommended by the manufacturer.
• Do not mix old and new batteries when inserting new ones.
16
• If the unit is not to be used for an extended period of time, remove the batteries
from the unit.
• Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
• Warning: excessive sound pressure from earphones and headphones can cause
hearing loss.
USING THE AC POWER SUPPLY
1. Make sure that the voltage indicated on the manufacturer's nameplate in the
battery compartment corresponds to the voltage supplied by your electrical
installation. If this is not the case, consult your dealer or service center.
2. Connect the electrical power cable the unit then plug it into the wall outlet. The
wall outlet must be located near the product and be easily accessible.
EN
Instruction Manual
5