Publicité
6. CLEANING AND MAINTENANCE
- Disconnect the device
- Clean regularly the metallic parts after each use by using only use non-abrasive
products, warm water and wash liquid: avoid the abrasive toweling. Rinse your
device with a wet sponge and dry it with a soft cloth.
- Dry the device with a clean soft cloth.
- Never clean the device under a water jet, the infiltrations would risk to damage it in
an irreparable way.
- Never immerse the cord or the plug in the water or quite other liquid to avoid any
electric shock.
- Every week, the container for the evaporation of condensation particles must be
cleaned with a wet sponge as well. To have an access, on the back of the display
remove the rear tole by unscrewing the 2 visible screws.
CAUTION: In places with a high rate of humidity (>60%), it is obligatory to
proceed to a total defrost every week.
7. TECHNICAL SPECIFICATIONS
Model
Effective Volume
Dimensions
Weight
Power
Gas
Temperature
Voltage
Frequency
Glasses
8. REALIZING A TOTAL DEFROSTING
Stopping the machine is mandatory once a week.
- Disconnect the device.
- Empty the window.
- Stop the showcase.
- Open the door of the window.
- Leave it out of operation for 24 hours.
- Wipe off water marks.
- Empty the evaporation water tank : remove the back grille of the showcase by
removing the 2 visible screws.
800
350 l
801x752x1402 mm
150 Kg
430 W
R 290
+2° à +10° C
220-240 V ~
50-60 Hz
615 x 540 mm (x3)
1200
500 l
1202x752x1402 mm
190 Kg
450 W
R 290
+2° à +10° C
220-240 V ~
50-60 Hz
940 x 540 mm (x3)
14
Publicité
