Publicité
2. Load cell interface of XK3190-DS3 adopts the interface mode of four-wire RS485 mode.
Indicator Interface Pins
Pin
Definition
No.
2
Signal
transmission
negative
(－T)
4
Signal
transmission
positive
(＋T)
3
Signal reception
negative
(－R)
5
Signal reception
positive
(＋R)
6
Positive pole of
power source (＋ V)
9
Negative pole of
power source (－V)
1
Shield
III. Connection between Printer and Indicator
1. The printer is equipped with standard parallel output interface and 25-core RS232 connector
assembly. See definition of its pins in Figure 2-4.
2. Printing directions:
▲! The printer may be used only after completing relevant settings. All relevant
paremeters of the printer must be set before using it.
▲! Connection between printing interface output pin of the indicator and the printer must
be accurate without fault. Only dedicated connecting wire for printing may be used.
(Indicator must be connected with printer by appropriative cable accurately.) If wrong
connection occurs, output interface of the indicator or that of the printer and even the
indicator and printer may be damaged.
▲! When using printer, connect all lines accurately at first, then switch on the power of
indicator and at last the power of printer. After use, please turn off the printer first
and then turn off the power of indicator and disconnect all the cables. Any reversed
operation may damage the indicator and printer. Please be careful.
▲! Printers are of various model and parameters, they may be not be compatiable with our
indicator. Please choose printers as remmended.
The printer must be equipped with reliable ground. Otherwise, this may disturb
regular performance of the indicator or even damage the indicator and printer.
IV. Connection between Scoreboard and the Indicator and Their Use
▲ ! Output pin of the scoreboard shall be connected accurately without fault. Error connection
may damage the output interface of indicator or that of scoreboard or even damage the
indicator and scoreboard seriously. The connection requires the use of dedicated connection
wires.
1. Interface of the scoreboard is 15-core RS232 connector (use in common with the serial communication
X K 3 1 9 0 –DS3
Sensor (load cell) Interface Pins ......
Connection Method
Zhonghang Electronic
Measuring Indicators
Co., Ltd.
Brown
Signal
Connect
reception negative
(－R)
Signal
Yellow
Connect
reception
positive
(＋R)
White
Signal transmission
negative
(－T)
Signal transmission
Blue
positive
(＋T)
Connect positive pole
Red
of power source (＋V)
Connect negative pole
Black
of power source (－V)
Connect the shielded
――
wire
Table 2-1-1 Digital Load Cell Connection
(Figure 2-4) Printer interface signal
(3)
Color of Corresponding Wire
Guangzhou Electrical
Measuring Indicators
Factory
White
Green
Yellow
Blue
Red
Black
――
Signal ground
Optional
Ningbo Benui Electric
Co.,
Ltd.
/Ningbo
Board Electric Co.,
Ltd.
White
Green
Light yellow or
brown
Blue
Red
Black
――
Publicité
