Publicité
LOCK MODE
This mode cannot be used to perform horizontal or vertical levelling, because the
laser lines are no longer self-balancing.
In this mode, the LED indicator will always shine red.
After switching on, the measuring tool generates a horizontal laser plan and
two vertical laser planes. To change the operating mode,press the operating mode
button .
All operating modes can be selected both with and without automatic levelling.
1. Keep the power switch o , press the mode button to turn on the laser. The laser
lines are now locked, and are no longer self-levelling.
2. Press the mode button repeatedly to change the laser projection mode.
3. Slope your self-levelling 360 ° line laser level to project a straight line for
reference. In this mode, the laser lines are projected continuously and will not
blink, even if the slope angle exceeds 4°.
4. To turn the laser o , press the mode button repeatedly until the laser shuts o .
Three LED indicate the battery fule gauge, green LED can provide 60% capacity,
orange LED can provide 30% capacity and the red LED only can provide 10%
capacity for using.
Indicator
Mode button
WARNING
!
When turning the laser on, always be aware of around you.
Never point the laser light at protecting your eyes and the
eyes of those anyone's face, including your own.
LASER LINE PROJECTION MODES
FR
ES
PT
IT
EL
PL
UA
RO
EN
Publicité
