Publicité
EN
Bluetooth
MODE
®
-
Select Bluetooth
®
-
Open the Bluetooth
the FONESTAR device and pair with it. The amplifier will play a 3 tone.
NOTE: this amplifier recalls the last paired device. So, if it is the same device, you do not need to perform
the pairing process.
-
Select the music on your smartphone/tablet and start playback.
-
Make sure your smartphone/tablet is loud enough to be heard through the speakers. This allows you to
control the volume from the amplifier itself at a later time without having to operate any other equipment.
-
Press / to switch songs or
NOTE: this mode allows you to change the equalization.
USB MODE
-
Select the USB mode if the USB device is already inserted or insert the device to activate the mode
automatically. The display will show 4 digits with track number (0001) and then playback time (00:00).
-
Press / to switch songs or
NOTE: this mode allows you to change the playback mode and equalization.
AUX MODE
-
Connect the device via the AUX stereo input (on the front of the unit) and select AUX mode. The display
will show AUX.
-
Activate the connected audio device (player, mixer, PC, smartphone, etc.) and start playback.
-
Make sure that the signal from your audio device is loud enough to be heard through the speakers. This
allows you to control the volume from the amplifier itself at a later time without having to operate any
other equipment.
FM MODE
-
Select FM mode. The display will show the tuned frequency (00.0).
NOTE: to use this mode, you need to connect an antenna to the FM rear panel.
-
Perform an automatic tuning of the stations to start using this mode by long pressing the button
-
Once you have finished, you can select the station you want to listen to between those tuned with
/ on the front panel or CH-/CH+ on the remote control.
CONNECTION
IMPORTANT: refrigerate the amplifier properly. To do this, make sure that the place where it is installed has
access to airflow and that the slots in the chassis are free of obstructions.
-
With the amplifier switched off, connect all audio sources. If you are going to use the FM radio, you will
need to connect an FM reception antenna.
-
Connect the low impedance loudspeakers to the loudspeaker output.
IMPORTANT: for proper operation and performance of the device, use the correct power, impedance
and frequency limits. Before connecting to other equipment, be aware of the conditions required in a
LOW IMPEDANCE installation. More information can be found at:
-
Check that the volume and gain controls are at minimum, connect the amplifier to power.
-
Turn on the amplifier.
-
Select the audio input using the MODE button.
-
Finally, adjust all volume, EQ (BASS and TREBLE) and BALANCE controls.
mode. The display will show BLUE.
settings menu on your smartphone or tablet to pair the amplifier. Locate and select
®
to play/pause playback.
to play/pause playback.
fonestar.com/downloads/install_fonestar_en.pdf
- 4 -
.
Publicité
