Publicité
1
Introduction
1.1
Product description
The product is a super-capacitor jump starter for 12V vehicle
batteries.
1.2
Symbols
Read the operating instructions carefully
and make sure that you understand the
instructions before you use the product.
Save the instructions for future reference.
This product complies with applicable EU
directives and regulations.
Recycle as electrical waste.
1.3
Product overview
Figure 1
1.
Start button
2.
Display
3.
USB charging port
4.
Socket for starter cable
5.
USB charging cable
6.
Clamp
7.
Starter cable
2
Safety
2.1
Safety definitions
Warning! If you do not obey these instructions, there
is a risk of death or injury.
Caution! If you do not obey these instructions, there
is a risk of damage to the product, other materials or the
adjacent area.
Note! Information that is necessary in a given situation.
2.2 Safety instructions for operation
Warning! If you do not obey these instructions, there
is a risk of death or injury.
● Read the warning instructions that follow before you use
the product.
● Do not use the product if you are tired, ill or under the
influence of alcohol, drugs or medicine. This has a
negative effect on your vision, alertness, coordination and
judgement.
● Do not allow any children or anyone who is unfamiliar
with the product to use it.
● Do not use the product if it is damaged.
● Do not disassemble or modify the product.
● The product must only be used for its intended purpose.
● Make sure that the clamps do not touch each other or the
same piece of metal.
● Do not put the product near combustible materials such
as carpets, cardboard, or paper.
● Do not expose the product to rain or snow.
● Do not put the product near heat sources and avoid
direct sunlight.
● Do not put the product on the vehicle battery when the
vehicle is to be started.
● Make sure the vehicle is stopped and the emergency
brake is engaged before the product is used to jump start
the vehicle battery.
3
Operation
Note! Fully charge the product before the first use.
Note! The product must be fully charged before each use.
3.1
To charge the product with a
vehicle battery
1
Connect the plug of the starter cable into the starter
cable socket (A). (Figure 2)
2
Attach the red clamp (+) to the positive terminal (+)
of the vehicle battery (B).
3
Attach the black clamp (-) to the negative terminal (-)
of the vehicle battery (C). The charging will start
automatically.
Note! When the product is fully charged, the display will
show "100%".
4
When the product is fully charged, disconnect the
black clamp (-) from the vehicle battery first and then
the red clamp (+).
5
Publicité
