Publicité
Problem
Heating up takes a long time.
and a number come on.
10.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Make sure, you operated the hob
correctly. If not the servicing by a service
11. TECHNICAL DATA
11.1 Rating plate
Model NIK85M00FB
Typ 62 D5A 01 AA
Induction 7.35 kW
Ser.Nr. .................
AEG
11.2 Cooking zones specification
Cooking zone
Nominal power
(maximum heat
setting) [W]
Left front
2300
Left rear
2300
Middle rear
2300
42
ENGLISH
Possible cause
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
Cookware is too small and receives
only a part of the power generated
by the cooking zone.
There is an error in the hob.
technician or dealer will not be free of charge,
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
PNC 949 598 347 00
220 - 240 V / 400 V 2N, 50 Hz
Made in: Germany
7.35 kW
PowerBoost [W]
3200
3200
3200
Remedy
Use cookware suitable for induction
hobs. Refer to "Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
For optimal heat transfer use cook‐
ware with bottom diameter similar to
the size of the cooking zone (i.e. the
maximum cookware diameter value in
"Technical data" > "Cooking zones
specification").
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
PowerBoost
Cookware diame‐
maximum dura‐
ter [mm]
tion [min]
10
125 - 180
10
125 - 210
10
125 - 210
comes
Publicité
