Service. For optimal
performance, we
recommend replacing
the Blade every 6
months, or as needed,
depending on use.
Use of incompatible
•
parts or aftermarket
parts may result
in damage to your
magic bullet
Combo
®
Blender or create
safety hazards that
may cause personal
injury or damage. When
ordering replacement
parts, always use
genuine magic bullet
parts and accessories
from
www.nutribullet.
nl /.be
or contact
Customer Service at:
0900-0935 (NL) or 088-
7461001 (BE).
electrical safety:
Modification, improper
use, and failure to follow
the instructions for proper
setup, use, and care
of your magic bullet
®
Combo Blender can
increase the risk of
serious personal injury,
death, or property
damage.
16
Do not use the unit
in countries or locations
with different electrical
specifications or
plug types.
Do not use the unit
•
with a voltage
converter device, as it
may cause electrical
shorting, fire, or electric
shock, resulting in
personal injury or
product damage.
Do not use the unit in
•
an area that is wet,
or anywhere it could
become wet.
To avoid a hazard due
®
•
to inadvertent resetting
of the thermal cut-out,
this appliance must not
be supplied through
an external switching
device, such as a timer,
or connected to a
circuit that is regularly
switched on and off by
the utility.
Do not attempt to
•
plug the unit into an
electrical outlet with
wet hands.
Do not use the cord,
•
plug, or Motor Base if it
has been immersed in
water or other liquids.
Any significant spillage
on, under, or around
the Motor Base should
be cleaned and dried
before plugging in and
using the unit.
Do not modify the
•
electrical cord in
any way.
If the supply cord is
•
damaged, it must
be replaced by the
manufacturer, its
service agent or
similarly qualified
persons in order to
avoid a hazard.
Do not operate any
•
unit with a damaged
electrical cord or plug.
The electrical cord and
plug are not suitable
for replacement.
If damaged, the
appliance should be
replaced. Contact
Customer Service
for assistance at:
0900-0935 (NL) or
088-7461001 (BE).
Do
not allow or place the
electrical cord near
or touching any hot
surfaces, heat source,
or flame, including
the stove.
Do not allow the
•
electrical cord to hang
over the edge of a table
or counter.
Do not pull, twist,
•
or damage the
power cord.
Overloading the unit
•
may overheat the
motor and engage
the thermal breaker.
If the internal thermal
breaker shuts off the
motor, unplug the
Motor Base and let it
cool for an hour before
attempting to use it
again. The thermal
breaker will reset when
the unit is unplugged
and the thermal
breaker cools down.
UNPLUG
Always
•
your magic bullet
®
Combo Blender when
it is not in use, and
when assembling,
disassembling,
changing accessories,
or cleaning.
NEVER
pull from the
•
power cord to unplug.
To unplug, grasp the
plug and pull from
the outlet.
17