Publicité
THE CUP FEELS HOT OR
WARM, FOLLOW THESE
STEPS:
1.
Cease blending
immediately and
unplug the unit from
the outlet.
2. LEAVE ALONE, DO
NOT
OPEN. Leave the
Cup where it is and
do not touch it or
allow others
to touch it. Do not
attempt to
continue blending.
3.
Do not attempt to
disengage the Cup
from the Motor Base.
DO NOT
attempt to
separate the Cup
from the Cross Blade
by heat or force, or
by prying apart the
components, which
may crack or shatter
the Cup and result in
bodily injury.
4.
Allow the Cup to cool
for at least
30 minutes.
5.
After 30 minutes,
check if the Cup is
8
completely cooled.
If still warm, allow to
cool more.
6.
If cool to the touch,
slowly disengage the
Cup from the
Motor Base.
7.
With the Cup pointed
away from your face
and body, cover the
blade with a towel
and slowly untwist
the Cross Blade
from the Cup to
gently release any
residual pressure.
warning!
NEVER
ATTEMPT TO
SEPARATE THE CUP
FROM THE CROSS
BLADE BY FORCING
OR PRYING APART
THE COMPONENTS.
THIS MAY CRACK OR
SHATTER THE CUP,
RESULTING IN BODILY
INJURY. IF YOU ARE
UNABLE TO UNTWIST
THE CROSS BLADE
FROM THE CUP,
CONTACT CUSTOMER
SERVICE. IF YOU ARE
UNABLE TO UNTWIST
THE CUP FROM THE
CROSS BLADE, NEVER
LEAVE THE SEALED
CONTENTS OUT
FOR A PROLONGED
PERIOD OF TIME.
THE CONTENTS MAY
FERMENT, CAUSING
THE CUP TO VIOLENTLY
SEPARATE FROM THE
BLADE, WHICH MAY
RESULT IN BODILY
INJURY OR PROPERTY
DAMAGE. DISPOSE
OF THE CUP AND
CONTENTS PROPERLY
SO YOU OR OTHERS
WILL NOT BE INJURED
IF FERMENTATION
CAUSES THE CUP AND
BLADE TO SEPARATE.
cup safety:
Proper Cup use is
important for the safe
operation of your magic
bullet
. Using the Cup
®
inconsistent with these
instructions may result
in bodily injury, property
damage, or damage to
your unit. Remember,
NEVER
blend hot,
warm, or carbonated
ingredients or liquid in
the magic bullet
Cup!
®
ALWAYS
securely tighten
the Cross
Blade to the Cup to
prevent leakage.
Always make sure the
•
Cup is securely locked
onto the Motor Base
before blending. The
motor will not turn
on unless the Cup is set
in the locked position.
Do not overfill or exceed
•
the MAX line. Exceeding
the MAX line can result
in leakage.
Do not remove the
•
Cup while the unit is
in operation.
NEVER
operate your
•
magic bullet
Cup
®
when empty.
Do not attempt to
•
disengage the Cup
from the Motor Base
if the Cup starts to
leak during blending.
Leakage can indicate
that the Cup is about
to separate from the
blade, which can
expose the Blade
and cause laceration
injuries. If you notice
leaking, unplug the unit
immediately and allow
9
Publicité
