POLTI VAPORETTO SV440 DOUBLE Guide De Dépannage page 3

EN EN
PROBLEM
The appliance does not turn
on.
No steam is coming out.
The appliance is on but
releases little steam.
The appliance releases too
much water on the floor.
Frescovapor deodorant is
not released when using
steam.
(only for the Polti Vaporetto
SV440/450_DOUBLE).
Steam too damp using
Frescovapor.
(only for the Polti Vaporetto
SV440/450_DOUBLE).
If problems persist or are not listed above, please contact a Polti Authorised Service Centre
(see www.polti.com for the updated list) or contact Customer Services.
TROUBLESHOOTING TROUBLESHOOTING
POSSIBLE CAUSE
No power.
Boiler out of water.
Appliance turned off.
The steam is set to the
Minimum level.
Steam adjustment dial set
to the maximum.
Deodorant selector in
OFF position.
Out of Frescovapor.
Clean the deodorant
dispenser valve.
The steam is mixing with
Frescovapor.
3
SOLUTION
Check that the appliance has
been connected to the mains, as
indicated in Section 1.
Disconnect the appliance from
the mains, fill the water tank
and wait about 15 seconds, after
which use the appliance.
Check that the appliance has
been connected to the mains, as
indicated in chapter 1.
Turn the steam adjustment knob
to increase the flow.
Reduce the flow of steam to
the minimum. If necessary,
momentarily stop the
disbursement of steam, while
continuing to brush the surface.
Place the selector in the ON
position.
Fill the dispenser with
Frescovapor.
Insert the end of a paper clip
into the valve's hole by pushing
it right to the end with slight
rotational movements.
Stop the dispensing of
Frescovapor as desired, to
reduce the humidity of the
steam.