Publicité
HOSE AND HOSE CONNECTIONS
The air supply hose recommended is 3/8" (10mm) I.D. If an extension hose is necessary, use 1/2"
(13mm) ID hose with couplings not less than 3/8" (10mm) I.D. The tool inlet thread is 1/4" NPT.
LUBRICATION
For maximum performance and tool life, an airline lubricator, set to deliver 1 drop per minute. Snap-
on IM6 Air Motor Oil is recommended. If an airline lubricator is not used, add 8 to 10 drops of air
motor oil to the air inlet at the start of the day and run the tool for 10-20 seconds.
Do not over lubricate because excess oil may contaminate the surface being sanded.
MAINTENANCE
Water, dust and other airline contaminants can cause rust and vane sticking. After long idle periods,
flush the tool with a few drops of oil and run for 10 seconds. This will help remove contaminants and
reduce the formation of rust.
OPERATION
Speed of the tool may be adjusted by turning the regulator located near the air inlet.
Disconnect tool from air supply before installing or removing backing
INSTALLING BACKING PADS
• Center pad on gear seat.
• Secure with 6 hex screws.
INSTALLING SANDING DISC
· PSA
Remove backing paper from sanding disc.
Center on backing pad and apply firm pressure.
· HOOK and LOOP
Center sanding pad on backing pad and apply firm pressure.
REMOTE VACUUM OPERATION
Attach vacuum hose from portable dust collection system to sander's vacuum swivel.
Catalog No.
PS4609
PS4609V
PS4809
We, Snap-on Tools Corporation, 2801 —80th Street, Kenosha, WI, 53141, USA, declare under our
to which this declaration relates are in conformity with the following standard or standards or other
January 1, 2009
Kenosha, Wisconsin, USA
Date and place of issues
WARNING
WARNING
Be sure the pad is the correct size for the tool.
A mismatch between tool and pad will cause excessive vibration.
SOUND AND VIBRATION READINGS
*Sound Pressure
dBA
80
80
80
*per PN8NTC1
DECLARATION OF CONFORMITY
sole responsibility that the products
PS4609, PS4609V & PS4809
normative document or documents:
EN 792, EN 292 Parts 1&2, ISO 8662, Pneurop PN8NTC1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EC Directives.
Power and Specialty Tools
Name and position of issuer
pads or sanding disc.
*Sound Power
dBA
91
91
91
*per PN8NTC1
Mark S. Pezzoni
President
4
*Vibration
m/s2
5.9
5.9
5.9
*per ISO 8662
Signature of issuer
Publicité
