Publicité
INTENDED USE
This tool is intended to be used with abrasive sanding discs for the finish sanding of materials such
as wood, metal, fiberglass and similar materials. If it is used for anything else, it is considered mis-
use, creates a hazard and may void the warranty.
AIR SUPPLY
The efficiency and life of this tool depend on the proper supply of clean, dry air at a maximum of 90
PSI. The use of an airline filter, pressure regulator, and lubricator is recommended. Before connect-
ing to tools, blow out the airline to remove water and dirt that may have accumulated.
Improperly repaired tools perform unpredictably.
Repair tools at an Authorized Snap-on Service Center.
Tools that perform unpredictably can cause injury.
Tools left connected to the air supply can start unexpectedly.
Always remove tool from air supply and activate trigger to bleed air line
before making any adjustments, changing accessories, or doing any
maintenance or service on tool. Make it a habit to check to see that all
adjusting keys and wrenches have been removed from tool before turning
it on.
Tools starting unexpectedly and flying keys and wrenches can cause injury.
Working in poorly lit areas makes it hard to see hazards.
Keep work area well lit.
Poorly lit work areas can cause injury.
Children are attracted to work areas.
Keep children away. All visitors must keep a safe distance away from work
area.
Children in work areas can be injured.
Unauthorized or untrained personnel can misuse unattended tools.
Store idle tools in a dry, high or locked-up place, out of the reach of
children.
Misused tools can cause injury.
Tools with the actuator left in the "ON" position when an unexpected air pressure
loss occurs can start unexpectedly when the air pressure is restored.
Release the actuator if an unexpected loss of air pressure occurs.
Unexpected tool starts can cause injury.
Tools with the actuator left in the "on" position can cause unexpected starts when
the tool is connected to the air supply.
Be sure actuator is off before hooking up air.
Unexpected starts can cause injury.
Sanders may coast for a short time after the trigger is released.
Be sure tool has come to a complete stop before setting it aside.
Sanders that do not come to a complete stop before setting aside can cause
injury.
Backing pads that are worn, damaged, nicked, bent, warped or burred can cause
the sanding disc to tear and burst.
Do not use backing pads that are worn, damaged, nicked, bent, warped or
burred.
Sanding pads that burst can cause injury.
Tools left connected to the air supply while making adjustments, changing
accessories, or doing any maintenance or service can start unexpectedly.
Always remove the tool from the air supply and activate the trigger to bleed
the airline before making adjustments, changing accessories, or doing any
maintenance or service.
Tools that start unexpectedly can cause injury.
The use of any accessory with this tool not provided or specified by Snap-on can
perform unpredictably.
Use only accessories provided or specified by Snap-on.
Tools that perform unpredictably can cause injury.
When disposing of a tool, do it in a way that does not harm personnel or
the environment.
3
Publicité
