Publicité
TIPS
• High ambient temperatures have a negative effect on energy use. Keep the appliance in a position away from direct
sunlight or other sources of heat.
• Keep ventilation openings free. Clogged openings lead to higher use of energy.
• Try not to open the door too often, especially when the weather is wet and hot. Once you open the door, mind to close it
as soon as possible.
• The space between the shelves and the rear wall of the cooling compartment must be unobstructed to allow the cool air
to circulate. Therefore don't place any food items against the back.
• Set the thermostat to a lower setting when the circumstances allow it.
• Before storing fresh cooked food, make sure the food has cooled at least to room temperature.
• Ice and frost layer increase energy consumption, so clean the appliance as soon as the layer is 3 to 5 mm thick.
• If the gasket is damaged or if it turns out that the sealing is poor, the energy consumption is substantially higher. To
restore efficiency, replace the gasket.
• Keep the condensor on the rear wall always clean, free of dust or any impurities.
• Always consider the instructions, otherwise the energyconsumption is substantially higher.
• If you will not use your appliance for a long time (e.g. in summer holidays), activate the stand-by mode. Clean your
appliance. Leave the door open to prevent humidity and smell.
7
troubleshooting
If your appliance is not working properly, it may be a minor problem, therefore check the following:
Problem
Appliance is not functioning;
light does not work
The temperature inside the
appliance is too high or too low
The interior light flashes
Water is running out of the
appliance
The appliance is excessively
noisy
The inside light is not working
Note: During normal use of the cooling appliance, different types of noises can occur that do not have any effect on the
correct operation of the appliance.
Noises that can be heard during normal use of the appliance are caused by the operation of the thermostat, compressor
(activation), cooling system (shrinkage and expansion of the material under the influence of temperature differences and
flow of cooling liquid).
24
•
English
Cause
The appliance is not plugged in
There is a power failure
The thermostat has been set
incorrectly
The door of the appliance
is opened too frequently or
remains open for too long
A large amount of warm
food has been placed in the
appliance in the last 24 hours
The ambient temperature
is higher or lower than the
temperature indicated in the
table with technical data
Air circulation vents are
blocked
The doos has been open for
too long or does not close
properly
Drain outlet is blocked
Has the appliance been
installed correctly?
The appliance is standing
against something
Lamp is defective
Solution
Plug the appliance in
Check the fuse box
Set the thermostat correctly
Open the door less often and/or reduce the time that
the door remains open
Temporarily set the thermostat to a lower position
The appliance is intended for operation in an ambient
temperature indicated in the table with technical
data supplied with the appliance
Clean the ventilation openings
Check there is nothing between the door that
prevents it from closing and close the door.
Clear the drain outlet with a skewer
Check the installation
Place the appliance in such a way that it is not
standing against anything
Contact the customer service department
Publicité
